The container office is similar to the building. It levels the surrounding area and the base of the partition wall. It is made of reinforced concrete, which is more solid. Then the pillars are connected with the skeleton with transverse beams, and the upper partitions, the outer wall panels and the doors and windows frame are connected; then the floor is laid and the upper floor is installed, then the roof truss and the roof panels are mounted; finally, the doors and windows are installed, and the vertical support is pulled. There are also sanitary ware, hardware and so on. Next, the resident container manufacturer will give us a detailed introduction to the matters needing attention in the process of construction! _________
1. The location of each component should meet the design requirements, and the location of field welding components should be precise, without false welding or leakage welding. Fasteners should conform to GB5782 rules. Bolts must be in accordance with the design requirements. Location devices should be correct and gaskets should be padded properly. No less or less filling should be allowed. Connection bolts between components must be tightened.
2. After welding and transportation on site, the primer spalling should be repainted with one layer of anti-rust paint, and the component exposed part should be repainted with two layers of top paint. No leakage, peeling, hanging and rust-back of the paint should be allowed.
3. The first piece of container office and wall must be corrected according to the layout. The corner and sunny corner of umbrella wall should be sealed with angle aluminium. The connection between the board and the board should be made of I-shaped aluminium. The walls should be vertical, the depth of insertion should be different, and the wall should be clean, the color should be different, the board seams should be neat, the nailing surface should be divergent, there should be no difference between the top and bottom, and the necessary parts should be self-tapping bolts. According to the design drawings, the position of the door and window of the container meeting room is marked, and the position of the door and window hole is cut out by cutting machine. According to the position of the door and window hole, the window is made of plastic steel window. The suspended ceiling of the bottom floor of the Beijing container moving room is leased.
4. The door and window positioning device is correct and bolted. The device opens sensitively without blocking. There should be no pitting and cracks in the glass. The glass is clean and the accessory device is strong.
5. Appearance Requirements: 1. The walls shall be vertical, flat and divided, and uniformly cleaned. (2) The walls should be clean, with different colours and neat joints. (3) The door and window lock switch is sensitive and can not be without accessories.
The above wonderful contents are provided by Jinan Resident Containers. More details about Resident Containers are welcome to consult our customer service staff on our official website: http://www.screendrip.com! We will reply to you as soon as possible! Thank you for your support!